Table of Contents
Advertisement
10
Configuring Security and Access
Password Procedures
Changing Passwords
This procedure describes how to change passwords.
1. Click C
2. Click the Users link in the Security and Access Configuration section.
3. Enter the current user's password in the O
4. Enter a new user's password in the N
5. Enter the new user's password again in the N
edit box; then click A
To make your changes permanent, click S
Adding Users
To add users:
1. Click C
2. Click the Users link in the Security and Access Configuration section.
3. In the A
characters) of the new user you want to add.
4. In the A
An
user with admin account privileges, enter 0 for the Uid. The monitor
account allows read-only access. To create a new user with monitor
account privileges, enter 10 for the Uid.
5. In the A
path name of a directory into which the user will log in. For example, if
the name of the new user is tester, you could enter a path /var/tester for
the home directory.
528
on the home page.
ONFIG
PPLY
on the home page.
ONFIG
: U
DD NEW USER
: U
DD NEW USER
account allows read/write access privileges. To create a new
admin
: H
DD NEW USER
LD PASSWORD
EW PASSWORD
EW PASSWORD
.
.
AVE
: edit box, enter name (eight or fewer
SERNAME
: edit box, enter the numeric user's ID.
ID
: edit box, enter the full Unix
OME DIRECTORY
edit box.
edit box.
(
)
VERIFY
Voyager Reference Guide
Advertisement
Table of Contents
