Activating And Deactivating The Cops Client - Nokia Voyager Reference Manual

7
Configuring Traffic Management

Activating and Deactivating the COPS Client

You must activate the COPS client to implement the COPS module you
configure. You can deactivate the COPS client to halt the COPS module
implementation.
1. Click either C
Management link on the home page.
2. Click the COPS link in the Traffic Management section.
3. Click the S
4. Click S
Perform the following steps to deactivate the COPS client. You can maintain
any existing module and role configuration. This configuration remains
available if you reactivate the COPS client.
1. Click either C
Management link on the home page.
2. Click the COPS link in the Traffic Management section.
3. Click the S
4. Click S
Changing the Client ID Associated with Specific
Diffserv Configuration
You can change a client ID on a running system. Typically, each client ID
refers to a specific policy or set of policies.
1. Click either C
Management link on the home page.
2. Click the COPS link in the Traffic Management section.
3. Click the Diffserv PIB link in the C
This action takes you to the COPS Diffserv specific configuration page.
426
on the Voyager home page or the Traffic
ONFIG
button in the COPS
TART
make your change permanent.
AVE
on the Voyager home page or the Traffic
ONFIG
button in the COPS
TOP
to make your change permanent.
AVE
on the Voyager home page or the Traffic
ONFIG
field. Click A
CLIENT
field. Click A
CLIENT
COPS M
ONFIGURED
Voyager Reference Guide
.
PPLY
.
PPLY
section.
ODULE