Synchronizing The Time On Cluster Nodes - Nokia Voyager Reference Manual

7
Configuring Traffic Management
5. To change the cluster IP address for an interface, enter a new IP address in
the C
S
6. To change the hash, click the drop-down arrow in the Hash Selection
column and select one of the options, then click A
Deleting a Cluster Configuration
If you want to delete all the cluster configuration information and remove a
node from a cluster, you must log into the node as admin. On the Clustering
Setup Configuration page, click D

Synchronizing the Time on Cluster Nodes

You probably want to keep the times on the cluster nodes synchronized. If you
run Check Point's VPN-1/FireWall-1, be sure to do so to prevent problems
with firewall synchronization.
To make sure that the time is synchronized on cluster nodes you must:
! assign the same time zone to each node
configure NTP so that each node gets its time from the same time server
!
Assigning the Time Zone
To conveniently assign the same time zone to each node, follow these steps:
1. Log into Cluster Voyager
2. Under System Configuration, click
3. Select the appropriate time zone.
4. Click A
All the cluster nodes are now set to the time zone you specified.
382
IP A
LUSTER DDRESS
.
AVE
.
PPLY
field for that interface, then click A
.
ELETE
Local Time Setup
Voyager Reference Guide
and
PPLY
and S
.
AVE
PPLY