Nokia Voyager Reference Manual page 386

7
Configuring Traffic Management
Creating Proxy ARP Entries for NAT
Refer to the following figure as you perform the procedure described in this
section.
Cluster
1. Log into any of the nodes using the IPSO command shell.
2. enter
ifconfig -a
3. In the response to this command, identify the output for the internal and
external cluster interfaces. In the example figure, eth-s1p1 is the internal
cluster interface and eth-s2p1 is the external cluster interface.
4. In the information about the internal and external cluster interfaces,
identify the cluster MAC addresses. Look in that output for
"
clustermac 1:50:5a:a:a:1
388
192.168.1.0
192.168.1.10
eth-s1p1
Firewall A
eth-s2p1
192.168.2.10
192.168.2.0
VPN-1/FireWall-1
Synchronization Network
" followed by a MAC address. For example
clustermac
Internal
Network
192.168.1.10
eth-s3p1
eth-s1p1
Firewall B
eth-s4p1 eth-s2p1
192.168.2.10
External
Network
Primary Cluster
Protocol Network
eth-s3p1
eth-s4p1
Secondary Cluster
Protocol Network
Voyager Reference Guide