Nokia Voyager Reference Manual page 218

5
Configuring Interfaces
4. Click A
5. To make your changes permanent, click S
Adding a Static ATM ARP Entry
1. Click C
2. Click the Interfaces link.
3. Click the logical ATM interface you want to configure in the L
column.
4. Click the ATM ARP Entries link.
5. Enter the IP address of the new static ATM ARP entry in the IP A
field in the Create a new static ATM ARP entry section and enter the VPI/
VCI number of the corresponding PVC in the VPI/VCI field.
The IP address has to belong to the subnet of the logical ATM interface
and the VCI has to be one of those configured for the interface.
Note
Whenever static ATM ARP entries are applied, dynamic entries are no
longer updated; therefore, new neighbors cannot be seen via a dynamic
InATMARP mechanism.
6. Click A
The newly created static ATM ARP entry appears in the S
ARP E
entry will be sent to the PVC specified in the entry.
7. To make your changes permanent, click S
218
.
PPLY
on the home page.
ONFIG
.
PPLY
table. The IP datagrams destined to the IP address of the
NTRIES
.
AVE
OGICAL
TATIC
.
AVE
Voyager Reference Guide
DDRESS
ATM