Nokia Voyager Reference Manual page 247

9. (Optional) To configure a multicast address for which this router is
Note
If you do not configure a multicast address for the router, it advertises as
able to function as the rendezvous point for all multicast groups (224/4)
10. Click A
11. To make your changes permanent, click S
Configuring a PIM-SM Static Rendezvous Point
1. Click C
2. Click the PIM link in the Routing Configuration section.
3. In the PIM I
4. Click A
5. In the Interfaces section, click the O
Note
There is no limit to the number of interfaces on which you can run PIM.
6. Click A
Voyager Reference Guide
c. (Optional) Enter the Candidate Rendezvous Point priority (0-255) in
the P
edit box.
RIORITY
Use the priority option to set the priority for this rendezvous point. The
lower this value, the higher priority. The default priority value is 0.
designated as the rendezvous point, in the Local RPSET field, enter an IP
address in the Multicast address group edit box and the address mask
length in the Mask length edit box.
.
PPLY
on the home page.
ONFIG
NSTANCE
.
PPLY
on which you want to run PIM.
.
PPLY
M field, click the O
ODE
radio button(s) for each interface
N
.
AVE
radio button for sparse.
N
247