Table of Contents
Advertisement
7
Configuring Traffic Management
9. Click A
10. Click U
11. Click The Y
12. Click A
13. Click S
Note
When you make changes to a transparent mode group, you must stop
and restart the firewall.
Once you have enabled transparent mode and restarted your firewall, packets
destined for your LAN are sent at Layer 2. Packets destined for an IP address
are sent at Layer 3.
Creating A Transparent Mode Group
You create a transparent mode group by first creating the group then adding
the interfaces to the group. (See
Group.") By default, a transparent mode group stays disabled unless explicitly
enabled. In the disabled mode, the transparent mode group will drop all
packets received on or destined to the interfaces in that group. (See
a Transparent Mode
following:
1. Click C
2. Click Transparent Mode in the Interface section
3. Enter any positive integer (an integer greater than 0) in the edit box.
4. Click A
Deleting a Transparent Mode Group
This procedure describes how to delete a transparent mode group.
442
.
PPLY
.
P
in the E
ES
NABLE
.
PPLY
to make your changes permanent
AVE
"Adding an Interface to a Transparent Mode
Group.") To create a transparent mode group do the
on the home page.
ONFIG
.
PPLY
column associated with XMG 100.
Voyager Reference Guide
"Enabling
Advertisement
Table of Contents
