Nokia Voyager Reference Manual page 390

7
Configuring Traffic Management
For example, the IP address for interface eth-s1p1 would be 192.168.1.1.
5. Click T
6. Under Traffic Management Configuration, click
display the Clustering Setup Configuration page.
7. Enter ID 10 for the cluster.
8. Enter a password for cadmin twice.
9. Click A
10. Set the cluster mode to multicast.
This example assumes that you want to use multicast mode to achieve the
maximum throughput. See
about this feature.
11. Configure the cluster interfaces.
a. Click Y
b. Enter each cluster IP address in the appropriate field:
!
!
!
!
Note
The cluster IP address must be in the same subnet as the real IP address
of the interface.
12. Select D
13. In the Primary Interface column, click Y
primary cluster protocol interface for the node.
14. In the Secondary Interface column, click Y
secondary cluster protocol interface for the node.
392
.
OP
.
PPLY
in the Select column of the Interfaces Configuration table
ES
for each appropriate interface.
For eth-s1p1, enter 192.168.1.10.
For eth-s2p1, enter 192.168.2.10.
For eth-s3p1, enter 192.168.3.10.
For eth-s4p1, enter 192.168.4.10.
as the hash method for each interface.
EFAULT
"Cluster Management"
for eth-s3p1 to make it the
ES
for eth-s4p1 to make it the
ES
Clustering Setup to
for more information
Voyager Reference Guide