Nokia Voyager Reference Manual page 87

Hide thumbs Also See for Voyager:

Table of Contents

Changing the IP Address of an FDDI Interface

Do not change the IP address you use in your browser to access

Voyager. If you do, you can no longer access the network application

platform (unit) with your browser.

2. Click the Interfaces link.

3. Click the logical interface link for which you want to change the IP

4. To remove the old IP address, click the

5. To add the new IP address, enter the IP address for the device in the N

6. Enter the subnet mask length in the N

To make your changes permanent, click S

FDDI Example

This section describes how you might configure the interfaces of your

network application platform (unit) in an example network, using Voyager.

Before you can configure the unit using Voyager, you must configure an IP

address on one of the interfaces. You can do this through the unit console port

Voyager Reference Guide

on the home page.

address in the L

corresponds to the address you want to delete, then click A

Each time you click A

added to the table. The entry fields remain blank to allow you to add more

IP addresses.

EW MASK LENGTH

, the new IP address and mask length are

check box that

edit box, then