Nokia Voyager Reference Manual page 298

6
Configuring Routing
Configuring IBGP on Nokia Platform C
1. Configure the interface as in "Configuring an Ethernet Interface".
2. Configure an internal routing protocol such as OSPF or configure a static
route to connect the platforms in AS100 to each other. For more
information
3. Click Config on the home page.
4. Click the BGP link in the Routing Configuration section.
5. Enter a router ID in the ROUTER ID edit box.
The defalt router ID is the address of the first interface. An address on a
loopback interface that is not the loopback address (127.0.0.1) is
preferred.
6. Enter
7. Enter
8. Click I
A
9. Enter
click A
Configuring Nokia Platform C as an IBGP Peer to
Nokia Platform A
1. Click Config on the home page.
2. Click the BGP link in the Routing Configuration section.
3. Enter
click A
Configuring EBGP on Nokia Platform A
1. Configure the interface on Nokia Platform A as in
Ethernet Interface"
2. Click C
298
"Configuring OSPF"
in the AS
NUMBER
100
in the P
EER AUTONOMOUS SYSTEM NUMBER
100
in the P
NTERNAL
.
PPLY
in the A
172.17.10.1
.
PPLY
in the A
10.50.10.1
.
PPLY
.
on the home page.
ONFIG
or "Creating a Static Route"
edit box.
drop-down window; then click
EER GROUP TYPE
DD REMOTE PEER
DD REMOTE PEER
.
edit box.
IP
edit box; then
ADDRESS
IP edit box; then
ADDRESS
"Configuring an
Voyager Reference Guide