Ipoa Example - Nokia Voyager Reference Manual

Hide thumbs Also See for Voyager:

Table of Contents

IPoA Example

This section describes how you might configure the interfaces of your

network application platform (Nokia Platform) in an example network, using

Before you can configure interfaces using Voyager, you must first configure

an IP address on one of the interfaces. You can do this through the Nokia

Platform console port during installation or by using the Lynx browser. This

allows a graphical browser such as Internet Explorer or Netscape Navigator to

access the Nokia Platform through that interface. You can use any graphical

web browser to configure the other interfaces on the unit by entering the IP

address of the unit in the location field of the browser.

The figure below shows the network configuration for this example.

A company has five ethernet networks in three separate locations. The

networks are connected to each other using three routers that belong to the

same logical IP subnet over ATM. We are configuring the ATM interface on

Voyager Reference Guide

atm-s3p1c0 (10.0.0.2/24)

Nokia Platform B

Nokia Platform A

atm-s2p1c0 (10.0.0.1/24)

PVC 42 to Nokia Platform B

PVC 53 to Nokia Platform C

atm-s3p1c0 (10.0.0.3/24)

Nokia Platform C