Disabling Pim - Nokia Voyager Reference Manual

Hide thumbs Also See for Voyager:

Table of Contents

rejected. A PIM router on a shared LAN must have at least one interface

address with a subnet prefix shared by all neighboring PIM routers.

6. (Optional) For each interface that is running PIM, enter a new designated

Although you can configure this option, PIM-DM does not use DR

Election Priority. On a LAN with more than one router, data-forwarding is

implemented on the basis of PIM Assert messages. The router with the

lowest cost (based on unicast routing) to reach the source of data traffic is

elected as the router that forwards traffic. In the case of a tie, the router

with the highest IP address is elected to forward traffic.

Disabling PIM

You can disable PIM on one or more interfaces you have configured on each

2. Click on the PIM link in the Routing Configuration section.

3. In the Interfaces section, click the O

Voyager Reference Guide

router priority in the DR E

the highest priority and the highest IP address is elected as the designated

router. The default is 1, and the range is 0-4294967295 (2^32 - 1).

, and then click S

on the home page.

on which you want to disable PIM. To disable PIM entirely, click the O

radio button next to each interface that is currently running PIM.

, and then click S

to make your change permanent.

radio button(s) for each interface

to make your change permanent.

edit box. The router with