Nokia Voyager Reference Manual page 241

Hide thumbs Also See for Voyager:

Table of Contents

9. In the General Timers section, enter a value for the data interval (in

10. In the General Timers section, enter a value for the assert interval (in

11. In the General Timers section, enter a value for the assert rate limit in the

12. In the General Timers section, enter a value (in seconds) for the interval

13. In the General Timers section, enter a value for the random delay join/

14. In the General Timers section, enter a value for the join/prune suppression

The join/prune suppression interval should be set at 1.25 times the join/

prune interval.

15. In the Assert Ranks section, enter a value for the routing protocol(s) you

Voyager Reference Guide

seconds) in the D

interval after which the multicast (S, G) state for a silent source is deleted.

seconds) in the A

interval between the last time an assert is received and when the assert is

per second at which the designated router sends assert messages. The

upper limit is 10,000 assert messages per second.

between sending join/prune messages in the J

prune interval (in seconds) in the R

edit box. This value represents the maximum interval between

the time when the Reverse Path Forwarding neighbor changes and when a

Join/Prune message is sent.

interval (in seconds) in the J

box. This value represents the mean interval between receiving a Join/

Prune message with a higher Holdtime and allowing duplicate Join/Prune

messages to be sent again.

are using in the appropriate edit box. Assert Rank values are used to

compare protocols and determine which router forwards multicast packets

edit box. This value represents the

edit box. This value represents the

edit box. The value represents the number of times