Removing An Ipsec Tunnel - Nokia Voyager Reference Manual

10
Configuring Security and Access
3. In the N
the IP address.
Example—
tun0c1
4. You are taken to the IPsec Tunnel page.
5. (Optional) Enter the IP address of the local end of the IPsec tunnel in the
L
The local address must be one of the system's interfaces and must be the
same as the remote address configured for the IPsec tunnel at the remote
router.
6. (Optional) Enter the IP address of the remote end of the IPsec tunnel in
the R
The remote address cannot be one of the system's interfaces and must be
the same as the local address configured for the IPsec tunnel at the remote
router.
7. Click A
8. To make your changes permanent, click S

Removing an IPsec Tunnel

Proposed New
1. Click C
2. Click the IPsec link.
The IPv4 IPsec General Configuration page is displayed by default. If the
IPv6 General Configuration page is desired, scroll to the bottom of the
page and click on the IPv6 IPsec General Configuration link.
3. Under the IPsec Tunnel Rules heading, click in the Delete square of the
tunnel name(s) you wish to delete.
4. Click A
614
column, click the name link for which you want to change
AME
A
edit box.
OCAL DDRESS
A
EMOTE DDRESS
.
PPLY
on the home page.
ONFIG
.
PPLY
edit box.
AVE
.
Voyager Reference Guide