Table of Contents
Advertisement
Note
This value must be identical to the keepalive value configured on the
system at the other end of a point-to-point link, or the link state fluctuates.
12. Click the DTE or DCE radio button in the I
13. Click the O
14. (Optional) Click the Advanced T1 CSU/DSU Options link to select
15. From the Advanced T1 CSU/DSU Options page, click the U
16. (Optional) Click the Advanced Frame Relay Options link to go to the
Voyager Reference Guide
This value sets the interval, in seconds, between keepalive protocol
message transmissions. These messages are used periodically to test for
an active remote system.
DTE is the usual operating mode when the device is connected to a Frame
Relay switch.
or O
N
FF
Click A
.
PPLY
Sets the monitoring of the connection-active status in the LMI status
message.
advanced T1 options.
The T1 CSU/DSU Advanced Options page allows you to configure
fractional T1 channels, line build-out values and other advanced settings
for the T1 device. The values you enter on this page are dependent on the
subscription provided by your service provider.
return to the physical interface page.
Frame Relay Advanced Options page.
The Frame Relay Advanced Options page allows you to configure frame
relay protocol and LMI parameters for this device.
radio button in the A
T
field.
NTERFACE
YPE
S
M
CTIVE
TATUS
ONITOR
P
field.
button to
159
Advertisement
Table of Contents
