Nokia Voyager Reference Manual page 603

Hide thumbs Also See for Voyager:

Table of Contents

IPSO can support up to 1500 rules. However, each Voyager page

displays a maximum of 10. If you create more than 10 rules, they are

continued on new pages. Access these pages by clicking the link directly

below the rule section. The link to more pages appears only after you

create more than 10 rules.

8. Click on the new link with the name you entered in the IPsec Tunnel

9. (Optional) Activate H

This and the following two steps are not applicable for tunnels without

logical interface parameters.

10. (Optional) If the hello protocol is active, enter a value for the H

11. (Optional) Change the interface's logical name to a more meaningful one

12. From the pulldown menu in the S

Voyager Reference Guide

Rules table. The IPsec Tunnel page is displayed.

The hello protocol determines the connectivity of an end-to-end logical

tunnel. As a result, the hello protocol modifies the link status of the

logical interface. If the connectivity of an unavailable tunnel is restored,

the hello protocol brings up the link.

between the Hello packets being sent through the tunnel. The D

edit box determines the interval (number of seconds) that you

do not receive an Hello packet before the link status changes to

unavailable.

by entering the preferred name in the L

name that is needed. Click A

inside the tunnel. Click A

edit boxes. Click A

edit box specifies the interval (number of seconds)

edit box. Click

field, select the policy