Nokia Voyager Reference Manual page 185

Configuring OSPF over an Unnumbered Interface
The graphic below represents an example configuration for running OSPF
over an unnumbered interface.
1. Configure the interfaces on Nokia Platform A and Nokia Platform B as in
2. For each Nokia Platform, configure an OSPF area as in
3. In the Interfaces section, click on the A
4. Click A
Note
Because the unnumbered interface uses the selected proxy interface's IP
address, whenever you change this proxy interface, OSPF adjacencies
are re-established.
Note
Whenever you change the unnumbered serial interface's underlying
encapsulation, for example from Cisco HDLC to PPP or from PPP to
Frame Relay, OSPF adjacencies are re-established.
Voyager Reference Guide
Area 2
Nokia
Platform A
"Configuring an Unnumbered Interface."
OSPF."
the configured unnumbered interface and select B
, and then click S
PPLY
Unnumbered Serial Link
Backbone
REA
to make your change permanent.
AVE
Nokia
Platform B
"Configuring
drop-down window next to
.
ACKBONE
Area 1
00043
185