Table of Contents
Advertisement
5
Configuring Interfaces
IP over ATM (IPoA)
Configuring an ATM Logical IP Subnet (LIS) Interface
1. Click C
2. Click the Interfaces link.
3. Click the physical interface link you want to configure in the P
column.
Example—
atm-s2p1
You are taken to the Physical Interface page.
4. Select SONET or SDH as the framing format in the P
C
The setting should match the type of transmission network to which the
interface is connected.
5. Select F
P
Freerun uses the internal clock. If two ATM interfaces are directly
connected, at least one of them must use the internal clock.
Loop timing derives the transmit clock from the recovered receive clock.
6. Select the VPI/VCI range in the VPI/VCI R
selection box.
7. Create a logical interface using the Create a new LLC/SNokia Platform
RFC1483 interface section by selecting LIS in the T
entering the set of VPI/VCI numbers that will be used by the interface in
the VPI/VCI edit box.
The set of VPI/VCIs can be given as a comma-separated list of VPI/VCIs
or VPI/VCI ranges such as 1/42, 1/48, 1/50-60.
8. Click A
136
on the home page.
ONFIG
table.
ONFIGURATION
or L
REERUN
OOP
C
HYSICAL
ONFIGURATION
.
PPLY
T
as the transmit clock choice in the
IMING
table.
ANGE
HYSICAL
HYSICAL
C
ONFIGURATION
selection box and
YPE
Voyager Reference Guide
Advertisement
Table of Contents
