Nokia Voyager Reference Manual page 461

For information about configuring VRRP rules for Check Point FireWall-1
4.1, contact the Nokia Technical Assistance Center (TAC).
Configuration Rule for Check Point NG FP1
Locate the following rule above the Stealth Rule:
Note
The object for VRRP is not the same as the gateway cluster object for HA.
Accordingly, in the example below, the gateway cluster object is
designated fwcluster-object.
Source
cluster-all-ips
Where:
cluster-all-ips
fwcluster-object
mcast-224.0.0.18
and of the type Host.
Configuration Rules for Check Point NG FP2 and
Later
You can use either of the following methods to configure the rule for
Check Point NG FP2 and later.
Voyager Reference Guide
Destination
fwcluster-object
mcast-224.0.0.18
is the Workstation object you created with all ips
is the Gateway Cluster object
is a Workstation object with the IP Address 224.0.0.18
Service Action
vrrp Accept
igmp
463