Cisco Hdlc Protocol - Nokia Voyager Reference Manual

5
Configuring Interfaces
The virtual link between Nokia Platform B and Nokia Platform C will
function because each Nokia Platform is configured with an IP address.

Cisco HDLC Protocol

Changing the Keepalive Interval for Cisco HDLC
1. Click C
2. Click the Interfaces link.
3. Click the physical interface link you want to configure in the P
column.
Example—
ser-s2p1
4. Enter a number in the K
C
Click A
This value sets the interval, in seconds, between keepalive protocol
message transmissions. These messages are used periodically to test for
an active remote system.
Note
This value must be identical to the keepalive value configured on the
system at the other end of a point-to-point link, or the link state fluctuates.
To make your changes permanent, click S
188
on the home page.
ONFIG
table to configure the Cisco HDLC keepalive interval.
ONFIGURATION
.
PPLY
edit box of the P
EEPALIVE
.
AVE
HYSICAL
HYSICAL
Voyager Reference Guide