Nokia Voyager Reference Manual page 145

4. (Optional) Click the O
5. If you turned the internal clock on, enter a value in the I
6. Click the F
7. Click the PPP radio button in the E
8. Enter a number in the K
Note
This value must be identical to the keepalive value configured on the
system at the other end of a point-to-point link, or the link state fluctuates.
9. Enter a number in the K
10. Click A
Voyager Reference Guide
table I
CONFIGURATION
the serial device, then click A
Set the internal clock to O
system that does not provide a clock source. Otherwise, set the internal
clock to O
.
FF
edit box.
SPEED
If the device can generate only certain line rates, and the configured line
rate is not one of these values, the device selects the next highest available
line rate.
D
ULL UPLEX
M
field.
ODE
Full duplex is the normal mode of operation.
A logical interface appears in the L
interval. Click A
PPLY
This value sets the interval, in seconds, between keepalive protocol
message transmissions. These messages are used periodically to test for
an active remote system.
This value sets the number of times a remote system may fail to send a
keepalive protocol message within a keepalive interval before the systems
considers the link down.
.
PPLY
or O radio button in the P
N FF
C
NTERNAL LOCK
.
PPLY
when you are connecting to a device or
N
or L radio button in the C
OOPBACK
NCAPSULATION
OGICAL
edit box to configure the PPP keepalive
EEPALIVE
.
EEPALIVE MAXIMUM FAILURES
HYSICAL
field to set the internal clock on
NTERNAL CLOCK
HANNEL
field. Click A
I
table.
NTERFACES
edit box.
.
PPLY
145