Table of Contents
Advertisement
5
Configuring Interfaces
10. Click the O
This sets the monitoring of the connection-active status in the LMI status
message.
11. (Optional) Click the Advanced Frame Relay Options link to go to the
Frame Relay Advanced Options page.
The Frame Relay Advanced Options page allows you to configure frame
relay protocol and LMI parameters for this device.
Note
The values you enter are dependent on the settings of the frame relay
switch to which you are connected or to the subscription provided by your
service provider.
12. From the Frame Relay Advanced Options page, click the U
return to the Physical Interface page.
13. Enter the DLCI number in the C
box. Click A
A new logical interface appears in the I
number appears as the channel number in the logical interface name. The
new interface is turned on by default.
14. (Optional) Enter another DLCI number in the DLCI edit box to configure
another frame relay PVC. Click A
Each time you click A
appears in the I
allow you to add more frame relay logical interfaces.
15. Click the logical interface name in the I
L
16. Enter the IP address for the local end of the PVC in the L
edit box.
17. Enter the IP address of the remote end of the PVC in the R
ADDRESS
148
or O
radio button in the A
N
FF
.
PPLY
PPLY
NTERFACE
OGICAL INTERFACES
edit box. Click A
CTIVE
REATE A NEW INTERFACE
NTERFACE
.
PPLY
after entering a DLCI, a new logical interface
column. The DLCI entry field remains blank to
NTERFACE
table to go the Interface page.
.
PPLY
S
M
field.
TATUS
ONITOR
button to
P
DLCI edit
column. The DLCI
column of the
OCAL ADDRESS
EMOTE
Voyager Reference Guide
Advertisement
Table of Contents
