Table of Contents
Advertisement
Voyager Reference Guide
Note
If the message indicates there are insufficient resources to
accommodate a larger buffer size, take appropriate actions and try
this procedure again. For further information, contact Nokia Technical
Assistance Center (TAC).
4. After you verify that the change is appropriate, issue the same
command without the
# ./modzap _fw_logalloc $FWDIR/boot/modules/fwmod.o
0x20000
A confirmation message is displayed, which you can safely ignore.
5. Reboot the system.
If you are using FireWall-1 NG, do the following:
1. Set the execute permissions by issuing a
2. To confirm that you have sufficient resources to increase the buffer
size, issue the following command:
modzap -n _fw_log_bufsize $FWDIR/boot/modules/
fwmod.o 0x200000
where
indicates a buffer size of 2MB, and the
0x20000
causes
to check the value at the symbol reported.
modzap
3. A console message is displayed confirming the change that will take
place when you issue the modzap command in the next step. You can
safely ignore this message.
Note
If the message indicates there are insufficient resources to
accommodate a larger buffer size, take appropriate actions and try
this procedure again. For further information, contact Nokia Technical
Assistance Center (TAC).
option:
-n
cpstop
command.
option
-n
63
Advertisement
Table of Contents
