!
!
Configuring Mail Relay
In Voyager, follow these instructions to configure mail relay for your firewall.
1. Click C
2. Click the Mail Relay link in the System Configuration section.
3. Enter either the IP address or hostname of the mail server that relays
4. Enter the username on the mail server to which mail addressed to
Sending Mail
This procedure describes how to send mail from the firewall.
1. Log into the firewall using either your
2. At the prompt, type the mail command, followed by a space, and the
3. Type the subject of your message at the subject prompt; then press enter.
4. Type your message; then press enter.
5. When you finish typing your message, type a period on an empty line;
Voyager Reference Guide
Ability to telnet to port 25
Support for mail accounts other than admin or monitor
on the home page.
ONFIG
outgoing e-mail in the M
is sent in the R
or
monitor
To make your changes permanent, click S
username of the recipient:
mail username@hostname
then press enter.
Your message will be sent.
S
edit box.
AIL
ERVER
U
edit box; then click A
EMOTE
SER
AVE
admin
PPLY
.
or
account.
monitor
admin
.
497