Route Aggregation Example - Nokia Voyager Reference Manual

4. To make your changes permanent, click S

Route Aggregation Example

The figure below shows the network configuration for the example.
In the above example Nokia Platform B, Nokia Platform C, and Nokia
Platform D are running OSPF with the backbone area. Nokia Platform A is
running OSPF on one interface and RIP 1 on the backbone side interface.
Assume that all the interfaces are configured with the addresses and the
routing protocol as shown above. Configure route aggregation of
192.168.24.0/24 from the OSPF side to the RIP side.
1. Initiate a Voyager session to Nokia Platform A.
2. Click C
3. Click the Route Aggregation link in the Routing Configuration section.
4. Enter
5. Enter
Voyager Reference Guide
Nokia
Platform B
24.46/30
all routers are running OSPF
Network Prefix: 192.168.0.0
24.45/30
Nokia Platform A
26.2/24
Advertise
192.168.24.0
Backbone running RIPv1
26.1/24
on the home page.
ONFIG
in the P
192.168.24.0
in the M L
ASK ENGTH
24
.
AVE
Nokia
Platform C
24.49/30 24.50/30
Backbone Area
REFIX FOR NEW AGGREGATE
edit box; then click A
24.53/30
24.54/30
Nokia
Platform D
00344
edit box
.
.
PPLY
277