Nokia Voyager Reference Manual page 190

Hide thumbs Also See for Voyager:

Table of Contents

Configuring Interfaces

3. Click the physical interface link you want to configure in the P

4. Enter a number in the K

interval, then click A

This value sets the interval, in seconds, between keepalive protocol

message transmissions. These messages are used periodically to test for

an active remote system.

This value must be identical to the keepalive value configured on the

system at the other end of a point-to-point link, or the link state fluctuates.

To make your changes permanent, click S

Changing the Keepalive Maximum Failures in PPP

2. Click the Interfaces link.

3. Click the physical interface link you want to configure in the P

4. Enter a number in the K

maximum failures. Click A

This value sets the number of times the remote system may fail to send a

keepalive protocol message within the keepalive interval before this

network application platform (unit) considers the link down.

on the home page.

ONFIGURATION

edit box to configure the PPP keepalive

EEPALIVE MAXIMUM FAILURES

table to configure the PPP keepalive

edit box of the

Voyager Reference Guide