Table of Contents
Advertisement
3. To enable the SNMP daemon, click the Y
Caution
To run the Check Point and SNMP daemons simultaneously, you
must start the Check Point SNMP daemon after you start VPN-1/
FireWal NG, If you start the Check Point SNMP daemon before you
start VPN-1FireWall-1 NG, the IPSO daemon does not start.
4. To disable the SNMP daemon, click the N
5. To make your changes permanent, click S
Setting an SNMP Agent Address
1. Click C
2. Click the SNMP link.
3. To configure a specific IP address on which the agent responds to
4. Click S
Note
The default is for the protocol to respond to requests from all interfaces.
Voyager Reference Guide
SNMP
field. Click A
DAEMON
All possible configuration options will appear, allowing you to enter the
necessary values.
SNMP
DAEMON FIELD
The configuration options disappear.
on the home page.
ONFIG
requests, enter the valid IP address of a configured interface in the A
N
A
edit box. Click A
EW
DDRESS
status appears on the Voyager page.
to make your change permanent.
AVE
ES
.
PPLY
O
. Click A
.
PPLY
AVE
. The IP address and its current
PPLY
radio button in the E
radio button in the E
.
NABLE
NABLE
GENT
635
Advertisement
Table of Contents
