Nokia Voyager Reference Manual page 443

5. Click A
6. Repeat steps 4 and 5 if you would like to delete other interfaces from the
7. Click A
Enabling a Transparent Mode Group
By default, a transparent mode group stays disabled unless explicitly enabled.
In the disabled mode, the transparent mode group will drop all packets
received on or destined to the interfaces in that group. You must enable the
transparent mode group to start the operation of the group. This procedure
describes how to enable a transport mode group.
Note
A transparent mode group must have at least one interface associated
with it for you to enable the group.
1. Click C
2. Click Transparent Mode in the Interface section
3. Click The Y
4. Click A
5. Click S
Disabling a Transparent Mode Group
This procedure describes how to disable a transparent mode group.
Voyager Reference Guide
.
PPLY
transparent mode group.
.
PPLY
on the home page.
ONFIG
radio button in the Enable column associated with the
ES
transparent mode group you would like to enable.
.
PPLY
to make your changes permanent
AVE
445