Routing Configuration - Nokia Voyager Reference Manual

Hide thumbs Also See for Voyager:

Table of Contents

Configuring IPv6

9. To specify the order in which next hops are selected, enter a value from

one to eight in the P

preferred the link.

The next preferred value is selected as the next hop only when an

interface fails. A non-reachable link is not selected as the next hop.

The preference option also supports equal-cost multipath routing. For

each preference value, you can configure as many as eight gateway

addresses. The nexthop gate address for each packet to the destination

is selected based on the nexthop algorithm that is configured.

Routing Configuration

Configuring RIPng

2. Click the RIPng link in the IPv6 section.

3. To enable RIPng, click the O

on which you want to run RIP, and then click A

4. Enter a value for the RIPng metric to be added to routes that are sent by

way of the specified interface in the M

, and then click S

on the home page.

, and then click S

edit box. The lower the value the more

to make your changes permanent.

Radio button next to the logical interface

to make your changes permanent.

Voyager Reference Guide