Nokia Voyager Reference Manual page 86

5
Configuring Interfaces
Changing the Duplex Setting of an FDDI Interface
Note
If the duplex setting of an FDDI interface is incorrect, it may not receive
data, or it may receive duplicates of the data it sends.
1. Click C
2. Click the Interfaces link.
3. Click the physical interface link you want to change in the P
column.
Example—
fddi-s2p1
4. Click the F
table D
Note
A device attached to a ring topology should be set to half duplex. If the
device is running in point-to-point mode, the duplex setting should be set
to full. This setting must be the same for all hosts on the network to which
the device connects.
To make your changes permanent, click S
86
on the home page.
ONFIG
or H radio button in the P
ULL ALF
field, then click A
UPLEX
HYSICAL
PPLY
.
.
AVE
Voyager Reference Guide
HYSICAL
C
ONFIGURATION