Nokia Voyager Reference Manual page 486

8
Configuring Router Services
SNTP
!
Configuring NTP
Configuring Network Time Protocol determines whether the time service
should be active or inactive. When NTP is active, the local clock will be
synchronized as configured, and hosts will be able to set their time via this
machine. If, however, you want to set the time manually, go to Setting the
System Time.
1. Click C
2. Click the NTP link in the Router Services section.
3. Click the Y
The NTP configuration page will display.
4. Enter the new server's IP address in the A
edit box. Click A
The new server's IP address will now appear in the NTP S
By default, this new server is enabled, v3 is selected, and the P
Y
them over the initial server you configured.
Note
It is recommended that you use the default setting of v3.
5. To add another new server, repeat step 4.
The new server's IP address will appear in the NTP S
default, this new server is enabled, v3 is selected, and the P
radio button is selected. If you wish to prefer this server over other
servers, click the P
6. To delete a server, click the corresponding
A
The new server's IP address will disappear from the NTP S
488
on the home page.
ONFIG
radio button in the E
ES
.
PPLY
radio button is selected. As you add other servers, you may prefer
ES
REFER
.
PPLY
NTP field. Click A
NABLE
DD NEW SERVER
Y
radio button. Click A
ES
OFF
.
PPLY
: A
DDRESS
field.
ERVERS
REFER
field. By
ERVERS
N
REFER
.
PPLY
radio button. Click
ERVERS
Voyager Reference Guide
:
O
field.