Nokia Voyager Reference Manual page 248

6
Configuring Routing
7. In the Sparse Mode Rendezvous Point (RP) Configuration section, to
enable a Static Rendezvous Point router, click the O
S
Note
Static Rendezvous Point configuration overrides rendezvous point (RP)
information received from other RP-dissemination mechanisms, such as
bootstrap routers.
8. Enter the IP address of the router that you want to configure as the static
rendezvous point in the RP A
9. (Optional) Enter the multicast group address and prefix length in the
M
A
Note
If you do not configure a multicast group address and prefix length for this
Static Rendezvous Point , it functions by default as the rendezvous point
for all multicast groups (224.0.0.0/4).
10. Click S
Setting Advanced Options for Sparse-Mode PIM
(Optional)
1. Click C
2. Click the PIM link in the Routing Configuration section.
3. In the PIM I
4. Click A
5. In the Interfaces section, click the O
on which you want to run PIM.
248
RP R
field.
TATIC OUTER
ULTICAST GROUP ADDRESS
.
PPLY
to make your changes permanent.
AVE
on the home page.
ONFIG
NSTANCE
.
PPLY
edit box. Click A
DDRESS
and M
ASK LENGTH EDIT
M field, click the O
ODE
radio button(s) for each interface
N
radio button in the
N
.
PPLY
boxes. Click
radio button for sparse.
N
Voyager Reference Guide