Configuration Overview - Nokia Voyager Reference Manual

7. Repeat this procedure on each of the other nodes that you upgraded from
You can now manage the cluster using Cluster Voyager or the CCLI.
Creating and Configuring a New Cluster

Configuration Overview

To create and configure a cluster, follow these basic steps:
1. Create a cluster on the first node.
2. Select the cluster mode.
3. Configure the cluster interfaces.
4. Enable or disable firewall monitoring, as appropriate:
5. Specify whether SecuRemote clients will be able to access servers behind
6. (Optional) Configure VPN tunnels.
7. (Optional) Configure IP pools.
Voyager Reference Guide
IPSO 3.6.
If VPN-1/FireWall-1 is running on the node, enable VPN-1/FireWall-1
!
monitoring before you make the cluster active.
If VPN-1/FireWall-1 is not running on the node, disable VPN-1/
!
FireWall-1 monitoring before you make the cluster active (so that the
cluster can be initialized). After the cluster is active, enable the
monitoring so that the cluster monitors the firewall and leaves the
cluster if the firewall fails on the node.
the cluster.
This step does not apply if you are using VPN-1/FireWall-1 NG with
Application Intelligence or later. It is sufficient to configure SecuRemote
access in FireWall-1.
This step does not apply if you are using VPN-1/FireWall-1 NG with
Application Intelligence or later. It is sufficient to configure VPN tunnels
in FireWall-1.
357