Nokia Voyager Reference Manual page 147

Hide thumbs Also See for Voyager:

Table of Contents

4. (Optional) Click the O

5. If you turned the internal clock on, enter a value in the I

6. Click the F

7. Click the F

8. Enter a number in the K

This value must be identical to the keepalive value configured on the

system at the other end of a point-to-point link, or the link state fluctuates.

9. Click the DTE or DCE radio button in the I

Voyager Reference Guide

CONFIGURATION

the serial device. Click A

Set the internal clock to O

system that does not provide a clock source. Otherwise, set the internal

If the device can generate only certain line rates, and the configured line

rate is not one of these values, the device selects the next highest available

Full duplex is the normal mode of operation.

keepalive interval. Click A

This value sets the interval, in seconds, between keepalive protocol

message transmissions. These messages are used periodically to test for

an active remote system.

DTE is the usual operating mode when the device is connected to a Frame

Relay switch.

radio button in the P

field to set the internal clock on

when you are connecting to a device or

radio button in the C

radio button in the E

edit box to configure the frame relay

NTERNAL CLOCK

field. Click

NCAPSULATION