Nokia Voyager Reference Manual page 129

Note
The Transmit Clock settings are available only if the ATM interface card
supports them.
6. Select the VPI/VCI range in the VPI/VCI R
7. Select
8. Click the logical interface name in the I
9. Enter the IP address for the local end of the PVC in the L
10. Enter the IP address of the remote end of the PVC in the R
11. Enter a number in the IP MTU edit box to configure the device's
Note
The maximum packet size must match the MTU of the link partner.
Voyager Reference Guide
Freerun uses the internal clock. If two ATM interfaces are directly
connected, at least one of them must use the internal clock.
Loop timing derives the transmit clock from the recovered receive clock
selection box.
- -
POINT TO POINT
LLC/SNokia Platform RFC1483 interface section. Enter the VPI/VCI
number in the VPI/VCI edit box. Click A
A new logical interface appears in the I
interface is turned on by default.
You can add more ATM logical interfaces by repeating this step.
L I
OGICAL NTERFACES
edit box.
A
edit box. Click A
DDRESS
maximum length (in bytes) of IP packets transmitted in this interface.
Click A .
PPLY
The default value is 1500.
in the T
selection box in the Create a new
YPE
PPLY
NTERFACE
NTERFACE
table to go to the Logical Interface page.
.
PPLY
C
ANGE ONFIGURATION
.
column. The new
column of the
A
OCAL
EMOTE
DDRESS
129