Nokia Voyager Reference Manual page 493

Creating a Mirror Set
This procedure describes how to create a mirror set:
1. Click C
2. Click the Disk Mirroring link in the System Configuration section.
3. Select the Create check box in the Create Mirror Set table.
Note
The source hard disk drive and the mirror hard disk drive should have
identical geometries. You can view hard disk drive geometry in the Drivers
Information table.
4. Click A
Note
The sync percent value in the Mirror Set table indicates the percentage of
sync zones that have been copied from the source disk to the mirror disk.
A sync zone is equivalent to contiguous disk sectors. When all sync
zones are copied to the mirror disk, the sync percent value will read 100
percent and your platform will be protected from a disk failure. Sync time
is approximately 20-30 minutes for a 20 GB disk. No mirror set is created
if the sync operation is not successful.
Deleting a Mirror Set
This procedure describes how to delete a mirror set.
1. Click C
2. Click the Disk Mirroring link in the System Configuration section.
Voyager Reference Guide
on the home page.
ONFIG
. You will see text at the top of the Voyager window with a
PPLY
message indicating a mirror set was created, numbers indicating which
hard disk drive is the source and which hard disk drive is the mirror, and
that mirror syncing is in progress.
on the home page.
ONFIG
495