Base Removal; Base Installation - Mazda RX-8 Manual

2. Install in the reverse order of removal.
AUTO-DIMMING MIRROR INSPECTION
1. Cover the day/night sensor on the back of the mirror with a piece of black paper or cloth.
2. In a well-lit area, shine a light at the mirror to simulate glare from vehicles to the rear. Verify that the
mirror dims automatically.
If not, replace the auto-dimming mirror.
•
NOTE:
The mirror will dim within 2 min if testing for the first time.
•

BASE REMOVAL

1. Remove the rearview mirror.
2. Wind each end of a wire around a bar.
WARNING:
Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using
•
the SST (piano wire).
NOTE:
Use a long sawing action to spread the work over the whole length of the SST (piano wire) to
•
prevent it from breaking.
3. Saw through the sealant to remove the base.

BASE INSTALLATION

1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
(w) RX-8 Body
Page 110