Table of Contents
Advertisement
Removing and Installing Drives
007-4278-001
4. If you will need access to the front panel drives, you will have to remove the bezel.
Follow these instructions if you need to remove the bezel:
a.
Remove the side panel as explained in Step 3.
b. Release the four tabs on the side of the bezel by gently lifting them out of the
chassis while at the same time pulling the bezel away from the system.
Figure 2-2 illustrates the procedure.
c.
After the four tabs are released, rotate the bezel away from the chassis.
Tab
Tab
Tab
Tab
Figure 2-2
Removing Bezel
This section covers the removal and installation of 5.25-inch and 3.5-inch drives in the
drive bays.
Removing and Installing Drives
17
Advertisement
Table of Contents
