E.1 Overview; E.1.1 Interface Access - Comtech EF Data CDM-625 Installation And Operation Manual

Appendix E. TELNET COMMAND
E.1 Overview
The Telnet Command Line Interface (referred to hereafter as the Telnet CLI or the CLI) is an
Ethernet-based user menu system for the CDM-625 Advanced Satellite Modem equipped with
an installed and enabled optional IP Packet Processor card. The CLI facilitates configuration,
monitoring and control of the unit using a user-supplied terminal emulator (e.g., PuTTY or Tera
Term).
E.1.1 Interface Access
Any changes made to the modem that are not saved to permanent storage during
the active session will be lost if the modem is reset or loses power. This applies to
all of the base modem and optional Packet Processor parameters. The parameters
can be saved by pressing [F8] on any Telnet CLI configuration page.
For connection via a Terminal Emulator: The user PC must have network connectivity to a
Traffic Ethernet Port of the IP Module. This connectivity can be via a local LAN, a remote LAN, or
via a satellite link from another IP modem.
LINE INTERFACE (CLI)
E–1
OPERATION