F.3.3.3.3.2 Odu: Fsk-Control  2Csats; F.3.3.3.3.2.1 Odu: Fsk-Control  2Csats  Csat#X; F.3.3.3.3.2.2 Odu: Fsk-Control  2Csats  Redundancy-Box - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Appendix F
F.3.3.3.3.2 ODU: FSK-control  2CSATs
The menus that follow assume that you have selected and the system has identified
two CSATs connected via the Rx IF port and the ODU Redundancy Controller Box.
1:1 Monitor & Control
CSAT#1
Use the ◄ ► arrow keys to select CSAT#1, CSAT#2, or Redundancy-Box, and then press ENTER.
F.3.3.3.3.2.1 ODU: FSK-control  2CSATs  CSAT#X
This submenu and its nested menus are identical in form and function for the
following menu structures:
ODU: FSK-control
ODU: FSK-control
CSAT-5060/050 V1.02
Configuration
◄ ►
Use the arrow keys to select Configuration, Monitor, Alarms, or Info, and then press
ENTER.
Sect. F.3.3.3.3.1 ODU: FSK-control
nested menu choices.
F.3.3.3.3.2.2 ODU: FSK-control  2CSATs  Redundancy-Box
Red: Online: ODU2
TxSw:OK
This menu provides operating mode and switchover controls. You may also view the following
read-only information here:
•
Which of the two CSATs in currently online (ODU1 or ODU2);
• Waveguide Switch Tx and Rx status: OK or Ft (fault);
•
Redundancy Controller Box 5V and 12V values (to aid trouble-shooting system
problems).
CSAT#2 Redundancy-Box
 CSAT 
2CSATs CSAT#X
 
Monitor Alarms

Mode:Auto
RxSw:OK 5V:5.0
F–21
()
(where CSAT#X = CSAT#1, CSAT#2)

Info ()
CSAT for complete information for these
Switch:N
12V:12.0
Revision 13
MN-CDM625