Table of Contents
Advertisement
CDM-625 Advanced Satellite Modem
Introduction
1.3.9
Supporting Hardware and Software
Redundancy Support: Comtech EF Data provides redundant operations support to the CDM-625
as follows:
•
For 1:1 redundancy applications, via its low-cost external CRS-170A L-Band and CRS-180
70/140 MHz IF 1:1 Redundancy Switches.
•
For M:N redundancy (hub) applications, via its external CRS-300 1:10 Redundancy
Switch or the CRS-500 M:N Redundancy System.
Transceiver Support: The CDM-625 is a companion product for Comtech EF Data's CSAT-5060
and KST-2000A/B RF Transceivers. The modem incorporates a Frequency Shift-keying (FSK) serial
link that can be activated on the Rx-IF port for the purpose of communicating with a transceiver,
if connected. In this manner, you may configure, monitor and control the transceiver using
either the CDM-625's front panel display and keypad or any of its remote control interfaces. The
EDMAC channel may also be used to convey M&C data to a transceiver at the distant end of a
satellite link, if it is connected to a CDM-625.
BUC Support: The CDM-625 incorporates an FSK serial link that can be activated on the Tx-IF
port for the purpose of communicating with an FSK-capable "smart" BUC. This link is designed to
be compatible with the Global VSAT Forum/ND SatCom specification. In this manner, you may
configure, monitor and control the BUC using either the CDM-625's front panel display and
keypad or any of its remote control interfaces.
Additionally, Comtech EF Data provides for an "Advanced FSK" for use with its LPOD BUCs, re-
using the existing FSK channel to pass additional "proprietary" commands to expand front panel
user control. The EDMAC channel can be used to convey M&C interface to a BUC at the distant
end of a satellite link, if it is connected to a CDM-625.
1–10
Revision 13
MN-CDM625
Advertisement
Table of Contents
