Config: Ip  Pktp-Enable - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Front Panel Operation
After defining and enabling an access list via SNMP or the CDM-625 Web Server interface
'Admin | Access' page, functionality of this menu appears as follows:
Host Access List is Enabled
Disable the List: No (N,Y)
arrow keys to select N (No) to maintain the active Host Access List, or Y to disable
Use the
▲▼
the list. Press ENTER when done. Once disabled, the following message appears whenever this
menu is selected:
Host Access List is Disabled
Use HTTP or SNMP to configure the list.
5.2.1.13.6 CONFIG: IP  PktP-Enable
This menu is visible/selectable only when the optional IP Packet Processor card is
installed.
Packet Processor: Enabled (Ena, Dis) ()
(Modem will auto-reboot after change!)
Use the arrow keys to select the card as Ena(bled) or Dis(abled), and then press ENTER. The
▲▼
modem will automatically reboot after this configuration change. Note the following:
•
The default mode is Ena(bled).
•
When the IP Packet Processor is disabled, the card and its accompanying functionality is
completely bypassed and the modem reverts to its base modem Layer 2 switch
functionality.
5–66
Revision 13
MN-CDM625
()