Comtech EF Data CDM-625 Installation And Operation Manual page 467

CDM-625 Advanced Satellite Modem
Appendix C
Step Task
The m odem r esponds with " Configured Successfully" i f th e FAST upgrade is accepted; the m odem
then resets to its newly-incorporated default configuration.
However, if an invalid code is entered, the following message displays:
Repeat the FAST access code entry procedure. Should the code entry error persist, contact Comtech
EF Data Customer Support for further assistance.
For Firmware Ver. 1.5.1 or earlier, enter the FAST access code for option
register(s) #1, #2 and/or #3 as required. For Firmware Ver. 1.5.2 and
later, all three FAST access codes must be entered in sequence in order
for the purchased option upgrades to be properly activated.
Failed to configure. Re-enter code.
88888888888888888888 then [ENTER]()
C–3
Revision 13
MN-CDM625