Config: Ip  Ant (Advanced Network Timing); Config: Ip  Ant  Sntp (Simple Network Time Protocol) - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Front Panel Operation
5.2.1.13.4 CONFIG: IP  ANT (Advanced Network Timing)
IP Protocols:
Use the arrow keys to select SNTP or PTP, and then press ENTER.
▲▼
5.2.1.13.4.1 CONFIG: IP  ANT  SNTP (Simple Network Time Protocol)
SNTP: Disabled (Disabled, Enabled)
Servers: Primary Backup
Simple Network Time Protocol (SNTP) is used to synchronize computer clocks throughout a
computer network when the ultimate performance of the full NTP implementation as per
RFC-1305 (Requests for Comment No. 1305: Network Time Protocol, Version 3, Specification,
Implementation and Analysis) is not needed or justified.
On the top line – Use the
SNTP contacts the time server to update the Real-Time Clock (RTC) every 24 hours. If Disabled,
no such notifications take place.
On the bottom line – Use the
select the Primary or Backup Server submenu. Pressing ENTER to continue:
[#######] Time Server: 192.168.001.010
Last Update: Never
(Where [######] Time Server denotes "Primary Time Server" or "Backup Time Server"):
On the top line – To edit the selected Time Server's IP Address, use the
a digit to edit, and then use the
On the bottom line – this read-only field displays the time and date that the selected server was
last updated. The time is shown in military format (HH:MM:SS); the date is shown in DAY-
MONTH-YEAR format in accordance with European convention. This line specifies "Never" if no
update information exists.
SNTP PTP
arrow keys to select SNTP as Enabled or Disabled. If Enabled,
▲▼
◄ ► arrow keys to first navigate to the bottom line, and then
arrow keys to change that digit.
▲▼
5–64
Revision 13
MN-CDM625
()
()
()
◄ ► arrow keys to select