Ifa-19G Board Replacement - Sony HDCAM HDW-F900R Maintenance Manual

6-15. IFA-19G Board Replacement

1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Open the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the front assembly.
(Refer to Section 6-1-1.)
4. Disconnect the harness and flexible card wire from the
connectors (CN120, CN501, CN504) on the IFA-19G
board.
n
Life of flexible card wire will be significantly short-
ened if it is folded. Be very careful not to fold the
flexible card wire.
5. Remove the nylon rivet and remove the IFA-19G
board.
6. When installing the new IFA-19G board to the frame,
insert the protruded portion in the right to the half-
round hole and insert the protruded portion in the left
into the groove. Then install the IFA-19G board
between the upper and lower protruded portions.
n
Upon completion of the IFA-19G board replacement,
remove EEPROM (IC202) from the former board and
install it to the new board.
7. Install it by reversing the steps of removal.
HDW-F900R/V1 (E)
Nylon rivet
CN501
CN504
Flexible card wire
IFA-19G board
CN120
Protruded
portion
Groove
in the left
Protruded
portion
in the right
Half-round hole
IFA-19G board
Frame
Upper
protruded
portion
Lower
protruded
portion
6-27