6-14. POWER Switch Replacement
1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Open the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the front assembly.
(Refer to Section 6-1-1.)
4. Disconnect the harness from the connector (CN504)
on the IFA-19G board.
5. Remove the nut and remove the POWER switch.
6. Install the new POWER switch by reversing the steps
of removal.
n
When the POWER switch is installed, direction of the
POWER switch must be set as shown in the illustra-
tion.
6-26
IFA-19G
board
POWER switch
Top view
RED
GRAY
To the front panel
CN504
Nut
POWER switch
HDW-F900R/V1 (E)