Skin Tone Adjustment - Sony HDCAM HDW-F900R Maintenance Manual

9-25. Skin Tone Adjustment

Note
Perform this adjustment as needed by the customer.
Preparation
. Complete the setup as shown below by using the setup
menu.
MENU : PAINT
PAGE : 10*SKIN DETAIL
ITEM : SKIN DETAIL ALL → ON
ITEM : SKIN AREA IND → ON
ITEM : SKIN DTL SELECT →
Select as desired by customer.
ITEM : SKIN DETAIL → ON
. Shoot face of human being.
Adjustment Procedure
Equipment : Either color monitor or view finder or
HD analog waveform monitor
Measurement point : TEST OUT connector or HD SDI
connector (rear panel)
1. Shoot face of human being in the window at the center
of VF screen.
2. Complete the setup as shown below by using the setup
menu.
MENU : PAINT
PAGE : 10*SKIN DETAIL
ITEM : SKIN DETECT → EXEC
(Automatic color detection is performed.)
3. Press the rotary encoder. (The detection range is
shown by the zebra pattern.)
HDW-F900R/V1 (E)
4. Perform the following procedures as needed by
customer.
Complete the adjustment as shown below by using the
setup menu.
MENU : PAINT
PAGE : 10*SKIN DETAIL
ITEM : SKIN DTL SAT. (Signal component in the
direction of saturation)
SKIN DTL HUE (HUE)
SKIN DTL WIDTH (Signal component in
the direction of color phase HUE)
HUE
WIDTH
SATURATION
The range in which the SKIN DETAIL is effective, is
shown by the zebra pattern on viewfinder. Adjust the
above items such that the zebra zone is not excessive nor
insufficient showing the effective range.
5. Complete the adjustment as shown below by using the
setup menu.
MENU : PAINT
PAGE : 10*SKIN DETAIL
ITEM : SKIN DETAIL LVL
Specifications : Adjust the detail signal level for the
customer's preference.
Setting upon Completion of Adjustment
. Complete the setting as shown below by using the setup
menu.
MENU : PAINT
PAGE : 10*SKIN DETAIL
ITEM : SKIN DETAIL ALL → OFF
ITEM : SKIN DETECT → OFF
ITEM : SKIN AREA IND → OFF
ITEM : SKIN DETAIL → OFF
R-Y
B-Y
9-25