P Fitting Bracket Assembly Replacement - Sony HDCAM HDW-F900R Maintenance Manual

6-11. 50P Fitting Bracket Assembly
Replacement
Removal
1. Remove the three screws (P2 x 4) and remove the
spacer.
2. Loosen the precision screw (with drop-safe) and
remove the connector cover assembly.
3. Remove the three screws (B3 x 8) and remove the V
mounted assembly.
4. Remove the five precision screws (P2.6 x 5). While
removing the 50P fitting bracket assembly, disconnect
the flexible card wires from the connectors (CN601,
CN602) on the CI-32G board.
n
Life of flexible card wire will be significantly short-
ened if it is folded. Be very careful not to fold the
flexible card wire.
Installation
5. Disconnect the flexible card wires from the connectors
(CN601, CN602) on the CI-32G board.
n
Life of flexible card wire will be significantly short-
ened if it is folded. Be very careful not to fold the
flexible card wire.
6. Align the position-setting hole of the new 50P fitting
bracket assembly with the position-setting pin of the
frame. Install it with the five precision screws (P2.6 x 5).
Standard tightening torque :
_2
53 x 10 N.m (5.3 kgf.cm)
7. Align the position-setting hole of the V mounted
assembly with the position-setting pin of the frame.
Install it with the three screws (B3 x 8).
Standard tightening torque :
80 x 10 _2
N.m (8 kgf.cm)
8. Install the connector cover assembly and spacer by
reversing the steps of removal.
HDW-F900R/V1 (E)
Connector cover assembly
Precision screw
(with drop-safe)
Position-setting pin of
the 50P fitting bracket assembly
Position-setting pins
of the V mounted assembly
Position-setting
hole
50P fitting bracket
assembly
Flexible card wires
Spacer
P2 x 4
CI-32G board
CN601
CN602
Precision screws
P2.6 x 5
Position-
setting holes
B3 x 8
V mounted assembly
6-21