Sony HDCAM HDW-F900R Maintenance Manual page 58

8. Remove the FL-283 printed wiring board from the
connector (CN1) on the CCM-45G board.
9. While removing the cable retainer 2, remove the FL-
283 printed wiring board.
n
Life of FL-283 printed wiring board will be signifi-
cantly shortened if it is folded. Be very careful not to
fold the FL-283 printed wiring board.
FL-283 printed wiring board
CCM-45G board
CN1
10. Loosen the five screws (with drop-safe) and move the
mechanical deck assembly as shown in the illustration
and remove it in the direction of the arrow.
Screw
(with drop-safe)
Screw
(with drop-safe)
1-48
11. Prepare the three EX-764 boards and the six flexible
12. Connect the flexible card wires (45 core) that come
Cable retainer 2
Notch
Mechanical deck
assembly
EX-764 board
Mechanical deck
assembly
Screws
(with drop-safe)
card wires (45 core). Assemble them as shown in the
illustration.
from the respective extension board, to the connector
(CN101) on MDC-13G board and to the connectors
(CN201 and CN202) on the MDC-13G board respec-
tively.
n
When extending the mechanical deck assembly, place
a protection sheet underneath the mechanical deck
assembly beforehand and extend it.
CN101
MDC-13G board
EX-764 boards
CN202
CN201
Protection sheet
HDW-F900R/V1 (E)