Removing And Reinstalling The Connector Box - Sony HDCAM HDW-F900R Maintenance Manual

1-6. Removing and Reinstalling the
Connector Box
Removal
1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Remove the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the DCP board assembly and the DVP board
assembly. (Refer to Sections 1-7-1 and 1-7-2.)
4. Slide the shoulder pad assembly in the direction of the
arrow.
5. Remove the two screws (P2 x 4). While removing the
VIDEO OUT assembly, remove the coaxial cable from
the groove.
6. Disconnect the harness from connectors (CN101 and
CN103) on CNB-23 board.
Shoulder pad
assembly
CN103
CNB-23 board
7. Disconnect the harness from the connector (CN114)
on the RM-201 board.
Harness
HDW-F900R/V1 (E)
VIDEO OUT assembly
P2 x 4
Coaxial cable
(Orange)
Groove
CN101
CN114
RM-201 board
8. Remove the two precision screws (P2.6 x 5) fixing
the DC IN connector and separate it from the shield
finger (BATT).
9. Remove the four screws (B3 x 8). Loosen the board-
to-board connector that is connected to the MB-1096
board. While removing the connector box assembly in
the direction of the arrow, remove the coaxial cable
and harness from the groove.
Coaxial cable (Brown)
DC IN connector
Board-to-board
connector
B3 x 8
Connector box assembly
10. Reinstall it by reversing the steps of disassembling.
m
. When attaching the VIDEO OUT assembly, route
the coaxial cable such that the coaxial cable passes
through the groove.
. If the coaxial cable is pinched between the frame
and the VIDEO OUT assembly or the CNBOX sub
panel, the coaxial cable can have open-circuit.
n
Standard tightening torque :
_2
P2 x 4 : 19 x 10 N.m (1.9 kgf.cm)
B3 x 8 : 80 x 10 _2
N.m (8 kgf.cm)
Groove
Board-to-board
connector
MB-1096
board
Shield finger
(BATT)
Precision screws
P2.6 x 5
B3 x 8
1-13